PIN Photodetector Manufacturers

Structural design optimization: The three basic principles of semiconductor lasers are: electrical injection and confinement, electrical-optical conversion, optical confinement and output, which correspond to electrical injection design, quantum well design, and optical field design of the waveguide structure, respectively. Optimizing the structure of quantum wells, quantum wires, quantum dots, and photonic crystals has promoted the continuous improvement of laser technology, making the output power and electro-optical conversion efficiency of lasers higher and higher, beam quality getting better and better, and higher reliability .

The traditional laser uses the thermal accumulation of laser energy to melt and even volatilize the material in the active area. In the process, a large number of chips, micro-cracks and other processing defects will be generated, and the longer the laser lasts, the greater the damage to the material. The ultra-short pulse laser has an ultra-short interaction time with the material, and the single-pulse energy is super strong enough to ionize any material, realize non-hot-melt cold processing, and obtain the ultra-fine, low-damage processing advantages incomparable with long-pulse laser. At the same time, for the selection of materials, ultrafast lasers have wider applicability, which can be applied to metals, TBC coatings, composite materials, etc.

Optical fiber splice, which connects two optical fibers permanently or detachably, and has a splice part for protecting the components. The optical fiber splice is the end device of the optical fiber. The optical fiber connector is a physical interface used to connect an optical fiber cable. FC is the abbreviation of Ferrule Connector. The external reinforcement method is a metal sleeve and the fastening method is a turnbuckle. The ST connector is usually used for 10Base-F, and the SC connector is usually used for 100Base-FX.

Direct Modulated Laser diode (DML) can be used to modulate optical power. In DML, the laser output power is adjusted by changing the pump current in the laser gain medium. The pump current is controlled by an electrical drive signal. This type of direct detection (DD) system typically uses On-Off Keying (OOK). In other words, the pump current of the DML is changed through binary signals.

In data centers, optical modules exist everywhere, but few people mention them. In fact, optical modules are already the most widely used products in data centers. Today's data centers are basically optical fiber interconnection, and the situation of cable interconnection has become less and less. Therefore, without optical modules, data centers cannot operate at all. The optical module converts electrical signals into optical signals at the sending end through photoelectric conversion, and then transmits through optical fibers, and then converts the optical signals into electrical signals at the receiving end. That is to say, any optical module has two parts: transmitting and receiving. The function is to do photoelectric conversion and electro-optical conversion, so that the optical modules are inseparable from the equipment at both ends of the network. There are thousands of devices in a medium-sized data center.